Apply with a heat press.
Start with the settings supplied for your particular film and fabric.
Check your transfer and fabric
Find the temperature, pressure, time, peel temperature and finishing instructions supplied with your transfer. If any are missing, email the studio before pressing. Test a spare piece of the same fabric first.
Prepare a flat pressing area
Set the press as directed. Smooth one layer of the garment over the platen, keeping seams, buttons and zips outside the print area. Pre-press for the specified time to remove moisture and creases.
Position and press
Lay the adhesive side against the fabric, with the carrier facing up and the design reading correctly. Use the protective sheet specified for your film. Apply the stated pressure for the full time.
Peel and finish
Lift the press straight up. Peel the carrier at the temperature specified for the film. If the design lifts with it, stop, lay it back down and check the instructions. Cover and finish-press if directed, then let the garment cool.
DTF Transfers Australia · Film-specific fitting instructions